4.5 ohm Data Line Filters 4

Reset All
Part RoHS Manufacturer Filter Type Construction Maximum DC Resistance Maximum Frequency Material Rated Current Minimum Insulation Resistance Approvals (V) Power Supply (V) No. of Functions Technology Screening Level Output Impedance (ohm) High Pot Packing Method Mounting Type Rated Voltage No. of Terminals Sub-Category Dimensions Case Code Maximum Operating Temperature Attenuation At Maximum Frequency Minimum Attenuation Frequency Package Material Minimum Operating Temperature Attenuation At Minimum Frequency Terminal Finish Inductance Maximum Attenuation Frequency Manufacturer Series Height Width (mm) Diameter (mm) Maximum Insertion Loss Additional Features JESD-609 Code Minimum Frequency Operating Frequency (Hz) Series Length Capacitance

TLF9UA103WR23K1

Taiyo Yuden

DATA LINE FILTER

4.5 ohm

.23 A

100 Mohm

1

BOX

THROUGH HOLE MOUNT

250 V

L17.0XB11.0XH16.0 (mm)/L0.669XB0.433XH0.63 (inch)

105 Cel

-25 Cel

4500 uH

16 mm

11.0

17 mm

TLF9UAH103WR23K1

Taiyo Yuden

DATA LINE FILTER

4.5 ohm

.23 A

100 Mohm

1

BOX

THROUGH HOLE MOUNT

250 V

L17.0XB15.0XH12.0 (mm)/L0.669XB0.591XH0.472 (inch)

105 Cel

-25 Cel

10000 uH

12 mm

15.0

17 mm

ACT45L-201-2P-TL000

TDK

EMI FILTER

4.5 ohm

.1 A

10 Mohm

2

AEC-Q200

TR, 13 INCH

SURFACE MOUNT

50 V

4

L4.5XB3.2XH2.8 (mm)/L0.177XB0.126XH0.11 (inch)

105 Cel

-40 Cel

TIN NICKEL COPPER

200 uH

2.8 mm

3.2

AEC-Q200

e2

4.5 mm

MCF20104G900-T

Taiyo Yuden

DATA LINE FILTER

4.5 ohm

.1 A

100 Mohm

1

90 OHM

TAPE

SURFACE MOUNT

8

L2.0XB1.0XH0.45 (mm)/L0.079XB0.039XH0.018 (inch)

.45 mm

1.0

2 mm

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.