2 A Data Line Filters 54

Reset All

Part	Manufacturer	Filter Type	Maximum DC Resistance	Rated Current	Minimum Insulation Resistance	No. of Functions	Screening Level	Output Impedance (ohm)	Packing Method	Mounting Type	Rated Voltage	No. of Terminals	Dimensions	Maximum Operating Temperature	Minimum Operating Temperature	Terminal Finish	Height	Width (mm)	JESD-609 Code	Length	Capacitance
DLW5ATH501MQ2K	Murata Manufacturing	DATA LINE FILTER	.034 ohm	2 A	10 Mohm	2	AEC-Q200	500 OHM	TR, EMBOSSED, 13 INCH	SURFACE MOUNT	50 V	4		125 Cel	-40 Cel		2.2 mm	3.6		5 mm
LCMGA201616T251NG	Taiyo Yuden	FERRITE CHIP	.05 ohm	2 A		1	AEC-Q200	250 OHM	TR, EMBOSSED	SURFACE MOUNT		2		125 Cel	-40 Cel		1.6 mm	1.6		2 mm
NFM15PC474D0G3D	Murata Manufacturing	FEED THROUGH CAPACITOR	.03 ohm	2 A		1			TR, PAPER, 7 INCH	SURFACE MOUNT	4 V	3	L1.0XB0.5XH0.3 (mm)/L0.039XB0.02XH0.012 (inch)	105 Cel	-55 Cel	TIN OVER NICKEL	.3 mm	0.5	e3	1 mm	470000 uF
NFM15PC915R0G3D	Murata Manufacturing	FEED THROUGH CAPACITOR	.04 ohm	2 A		1			TR, PAPER, 7 INCH	SURFACE MOUNT	4 V	3		85 Cel	-55 Cel	TIN OVER NICKEL	.5 mm	0.5	e3	1 mm	9100000 uF
ACMP-5045-351-T	Abracon	DATA LINE FILTER	.04 ohm	2 A	10 Mohm	2		350 OHM	TR, 13 INCH	SURFACE MOUNT	50 V	4		125 Cel	-40 Cel		4.5 mm	4.8		5 mm
ACP3225-501-2P-TL000	TDK	DATA LINE FILTER	.04 ohm	2 A	10 Mohm	2		500 OHM	TR, 13 INCH	SURFACE MOUNT	60 V	4		85 Cel	-40 Cel		1.9 mm	2.5		3.2 mm

Data Line Filters

Data line filters are electronic filters that are used to filter out noise and interference from data communication lines. They are designed to provide a high level of attenuation of unwanted frequencies while allowing the desired data signal to pass through with minimal distortion.

Data line filters use a combination of passive and active components, including resistors, capacitors, inductors, and op-amps, to filter out noise and interference from data communication lines. They can be designed for a wide range of communication standards, including Ethernet, USB, HDMI, and other data communication protocols.

Data line filters can be designed as low-pass filters, which allow low-frequency signals to pass through while attenuating high-frequency signals, or as band-stop filters, which block a specific range of frequencies while allowing other frequencies to pass through. They can also be designed with multiple stages of filtering to provide increased attenuation of unwanted frequencies.

Data line filters are commonly used in a variety of electronic systems, including computers, telecommunication equipment, medical equipment, and industrial control systems. They are also used in data centers and other applications where high-speed data communication is critical.